vitrification point
英
美
玻化温度，玻璃化温度
双语例句
- But as for the hot-filling crystallized bottle, it is of great important to assure the sufficient stress discharge at a temperature above the vitrification point for the coming filling operation.
对充气饮料瓶来说，它可抗内压，有好处，但对热灌装瓶来说就要保证在玻璃化温度以上让它充分释放。 - The size and distribution of SBR latex particles were determined by laser scattering. The vitrification point and the microstructure of MBS resin were investigated.
研究了SBR粒径大小及其分布、MBS玻璃化转变温度以及其微观形态。 - The results showed that when heating temperature is near the vitrification point, compression speed influences the quality of the parts directly.
结果表明：加热温度在聚碳酸酯玻璃化温度（Tg）附近时，加压方式直接影响试件的质量； - Based on the theory analysis of measured data, it is believed that the vitrification point of polytetrafluoroethylene is 100 ℃ approximately;
基于实测数据的理论分析，认为：聚四氟乙烯材料的玻璃化温度大约为100℃； - The vitrification point is about 182.92 ℃, higher than that of the cellulose or semi cellulose.
DSC的结果说明柿叶的玻璃化温度约为182.92℃左右，高于纤维素和半纤维素。 - A Comparison on Cytoplasmic Vitrification and Freezing Point of Chinese Fir and Masson Pine Seeds
杉木、马尾松种子细胞质冻结和玻璃化的比较 - The curve of the vitrification point ( T_g) intersects with that of the cloud point at a PPE content ( mass fraction, below the same) of about 60%;
玻璃化转变温度（Tg）线和浊点曲线在PPE含量约为60%（质量分数，下同）时相交，当PPE含量小于60%时，PPE/TAIC体系的玻璃化温度约为323K； - The vitrification point of adhesive with different nano-SiO2 addition was tested by DSC and it was improved by addition of nano-SiO2 particles. The vitrification point of adhesive with 4% nano-SiO2 addition was 4.23 times larger than unmodified.
利用差示扫描量热仪测试不同纳米SiO2添加量的玻璃化温度，发现玻璃化温度随着纳米粒子添加量的增大而提高，添加4%纳米SiO2后的胶粘剂玻璃化温度提高了4.23倍。 - A comprehensive research was conducting on the relations among its solidified behavior, vitrification point, adhesive power, impact strength and peel strength.
研究了导电涂层固化行为与玻璃化温度、附着力、冲击强度和剥离强度之间的关系，确立了导电涂料的最佳固化条件。